"Britain" Duplex Built from 3D Printed Concrete Blocks
House kit of hollow 3D printed concrete wall blocks for the "Britain" duplex.
Discuss your order Message on Viber
| Type | duplex |
| Delivery | wall kit, blocks labeled and palletized |
| Production time | 6 weeks on average |
| Installation supervision | by an experienced mason trained in the system |
| Project | wall drawings, renderings and a quote for your plot |
"Britain" is a two-family home with a striking British-style facade. Each half is fully independent, while the shared wall and foundation keep the budget down. The walls are assembled from concrete blocks printed in our workshop, so the shell goes up quickly and comes with a finished facade.
Inside each wall block
- a separate 350 mm cavity for cast-in-place foam concrete insulation
- vertical 200 × 200 mm channels for cast-in-place reinforced concrete columns
- built-in conduits for electrical wiring routed from the ceiling
- special blocks for the cast-in-place ring beam, included in the kit
Why it pays off
The facade needs no cladding: high-grade concrete can be painted in any color. Interior walls can be left unplastered, with the printed texture exposed. More than 10 houses have already been built in Ukraine using this technology.
We can also print
Stairs, fencing, flower beds, planters and other landscaping elements for the same house.
Frequently asked questions
What concrete do you print with?
Heavyweight concrete made with clean cubical crushed stone up to 10 mm, with no dusty screenings. The sand is quarry sand; clay and metal particles are removed by a powerful magnet above the conveyor. For thin-walled products we use only fresh M500 cement, which does not cause efflorescence, plus a plasticiser. Because the layers are compacted by extrusion rather than vibration, the mix contains more cement than ordinary concrete.
Why is every element 20 cm high?
Our production is standardised around this height. Almost any structure can be broken down into blocks in multiples of 20 cm with monolithic joints. This height gives precise layer geometry without the "elephant foot" effect and a manageable block weight: 40 kg on average, about 60 kg at most, so two people can lift it.
Will 3D printed concrete crack?
Every structure includes monolithic joints that carry the dead load, wind and snow, as well as expansion joints, composite reinforcement and coarse aggregate that acts as micro-reinforcement. As a result, the products withstand transport over 1,500+ km and all service loads. The design service life is over 100 years.
How are the products reinforced?
Each printed contour is reinforced twice along its height with certified composite rebar from a trusted manufacturer (Arvit). It does not lose its properties over time.
How do you ensure the layers bond into a solid whole?
Layer-to-layer adhesion is the key to 3D printing. We control the layer deposition time, concrete workability, air humidity and temperature, and the products are cured in a steam chamber.
Does a fence need a strip foundation?
No. Most fences are installed on point pier foundations with vertical rebar starters (usually 2 bars of 12 mm diameter). The entire load of a section is transferred to the monolithic joints, so a strip foundation is unnecessary, and a pier foundation cuts the amount of reinforcement and concrete work by about 5 times. Houses, of course, need a strip foundation or an insulated slab foundation.
I already have a strip foundation with posts. Will it work?
Send us the measurements and post spacing, and we will design a matching structure. If they don't match, the old posts or rebar are cut off and new anchors are set with chemical anchoring, or rebar is driven into the existing foundation.
My dog digs under the fence. What can I do?
Rather than building a strip foundation, it is more cost-effective to bury the bottom 1–2 rows of the fence. W6 concrete performs well in the ground.
Let's discuss your project
Leave your phone number and we'll call you back within one business day. Or message us on Viber.
Or call us:
+38 067 401 00 94